FAAC 770 Underground Swing Gate Operator-FAAC Automatic Swing Operator
		FAAC 770 swing gate operator is designed for residential and in-ground applications. The FAAC 770 is a 24 VDC operator that features a 100% duty cycle. The FAAC 770 is an in-ground operator and can swing a gate leaf of up to 10 ft. in length and weighing up to 800 lbs. The FAAC 770 COMPACT automation system for swing gates is a geared motor. It is designed for underground installation and therefore does not alter the appearance of the leaf. The foundation box of the automation system comes ready to take an operator. The FAAC 770 electromechanical operator is irreversible, so it ensures a mechanical stop and eliminates the need to install an electric lock.  Spec Sheet  Manual

FAAC 770 Basic Single Gate Operator Kit - Includes 24VDC Operator, Support Box, 425D Control Panel, 14x16 in. Enclosure, Transformer and Batteries (2)" -- $1,769.33
 

FAAC 770 Operator - Only Use to make single unit into Master/Slave (Bi-Parting) Kit or use to order replacement operator. Order necessary five wire cable and Additional Support Box for Bi-Parting System. -- $712.00
 

FAAC 770 In Ground Swing Gate Operator
Specifications  
* Duty Cycle
* 50 cycles per hour  
* Maximum Gate Swing 120 Degrees  
* 90 Degree Opening time 13 Seconds  
* Maximum Weight per gate leaf 800 lbs. (363 kg)  
* Maximum length per gate leaf 10 feet (3 m)  
* Approx. operating temperature range -4°F to 131°F (-20°C to 55°C)  
* Voltage Primary: 115vac
* Secondary: 2vac (100va transformer)  
* Power Consumption 40 W   
* Current Consumption 2 A   
* Effective Stroke 16.5 in. (41.9 cm)   
* Protection Class Nema 4x

FAAC 770 In Ground Swing Gate Operator
The FAAC 770 Compact automation system for swing gates is a geared motor. It is designed for underground installation
and therefore does not alter the appearance of the leaf. The operators are controlled by an electronic control unit mounted in an
enclosure which assures adequate protection against atmospheric agents.
The leaves are normally closed. When the electronic control unit receives an open command from the remote radio control or any
other control device, it activates the electromechanical system and causes the leaves to rotate by an angle of up to 110° to their
open position, so as to allow access.
If automatic operation has been selected, the leaves close automatically after the selected pause time. If semiautomatic operation
has been selected, a second impulse must be sent to close the leaves. An open command given while the leaves are closing
causes the leaves to reverse direction of movement. A stop command (if available) stops movement at any
time.
For detailed information on the operation of the automation system in the various operating modes, contact the installation
technician. The automation system is equipped with a safety device consisting of photocells. When the photocells are darkened by
an obstacle, they prevent the leaves from closing. The 770 Compact automation system is also equipped with
an anti-crushing safety device (fitted as standard) that limits the torque transmitted to the leaves. The operators ensure that the
system is mechanically locked when the motor is not running, so there is no need to install a lock. The leaves can be opened
manually only by operating the unlocking device. The lamp flashes while the leaves are moving.